ProCurve does not recommend configuring a voice VLAN to accept jumbo packets. Voice VLAN packets are typically small, and allowing a voice VLAN to accept jumbo packet traffic can degrade the voice transmission performance.

Beginning with Release H.08.89, LLDP-MED is supported on ProCurve Series 2600 switches.

These rules affect advertisements of VLANs in network policy TLVs:

• The VLAN ID TLV subelement applies only to a VLAN configured for voice operation: vlan < vid > voice
• If there are multiple voice VLANs configured on a port, LLDP-MED advertises the voice VLAN having the lowest VID.
• The voice VLAN port membership configured on the switch can be tagged or untagged. However, if the LLDP-MED endpoint expects a tagged membership when the switch port is configured for untagged, or the reverse, then a configuration mismatch results. (Typically, the endpoint expects the switch port to have a tagged voice VLAN membership.)
• If a given port does not belong to a voice VLAN, then the switch does not advertise the VLAN ID TLV through this port.

The QoS and voice VLAN policy elements can be statically configured with the following CLI

commands:

vlan < vid > voice
vlan < vid > < tagged | untagged > < port-list >
int < port-list > qos priority < 0 - 7 >
vlan < vid > qos dscp < codepoint >

Minimum software versions for LLDP-MED.

Source: HP ProCurve LAN products software feature matrix

LLDP-MED (Media Endpoint Discovery) H.08.89 R.11.04 R.11.04 T.11.xx W.14.03 L.10.02  K.14.xx K.11.1x K.14.xx E.10.02 H.07.57 K.14.03 K.14.xx K.12.31